Please try again later.

Pour approximately 4 oz of Spectracide Stump Remover Granules into each hole. Then fill with hot water to dissolve the granules. Continue to add water to the holes for several days to ensure Spectracide Stump Remover Granules dissolve completely. Allow the decomposition process to take place for four to six weeks before removing the stump.

To remove stumps, drill several 1-inch holes up to 12 inches deep into stump. Then into the side of the stump, approximately 3 to 4 inches from the top, drill a 1-inch hole slanting down to connect with the bottom of the center hole. Pour approximately 4 ounces of Spectracide Stump Remover /5(3K).

Mar 12, Decomposition, depending on the size of the stump, may take several weeks or months. Prior to using Spectracide Stump Remover Granules, freshly cut stumps should be killed with a brush stumpcutting.bar product works best when weather is warm and stumps are dry. To remove stumps, drill several 1-inch holes up to 12 inches deep into stump/5. Then down the side of the stump about" I drill 3 holes at a slant to connect a couple vertical holes to act as"breather holes" at the inner center of the stump.

Pour hot water slowly and carefully down the vertical holes and repeat product/hot water times depending on the wood - my trees were maple and quite hard wood.4/5(K). Prior to using Spectracide stump remover granules, freshly cut stumps should be killed with a brush stumpcutting.bar Product works best when weather tree pruning rentals warm and stumps are dry.

To remove stumps, drill several 1-inch holes up to 12 inches deep into stump. Then into the side of the stump, approximately 3 to 4 inches from the top, drill a 1-inch hole 4/5.