GMC Savana model years,,,,.

Use DT for /8" ID. Use J for /8" ID. Used to remove and install the rear output shaft bearing without removing and disassembling the transfer case.

Once the driveshaft is removed, the tool is expanded into the bushing, and its forcing screw is tightened against the output shaft to remove the stumpcutting.bar: SPX/Bosch (OTC Rotunda Kent-Moore Miller). Apr 05, Back story - for those who even care - I stopped the last video short because I wanted the dril a hole the correct size to hold the shaft - with that done le.

GMC Canyon model years, and

Dec 11, Trophy Points: Location: Opelousas La. It's just as easy to remove the tailshaft housing from the transmission and remove the bushing standing up, instead of laying under the car. Last one I did, all I used was a screw driver and hammer to remove it, once it was out of the car. Come think of it, I don't see how either of those tools.

Nov 11, Yes Just remove the drive shaft and use a short chisel/screw driver and hammer. Tap it out evenly; you'll bend it up a bit on the way out. Clean the surface in the t-case and apply a thin layer of oil and push the new one right into place I did it by hand. Just make sure you end up. Sep 23, Jeep Cherokee XJ Pioneer Renix L I6 AW4 NP 6" RE Lift 35"x" STT ProsFollow me on Facebook and Instagram!stumpcutting.bar