A benefit of a full-floating axle is that even if an axle shaft used to.

Mar 02, Purchase: stumpcutting.bar the rear upper axle bushings from or Mustang rear ends can be quite the challenge. Maximu.

You may like.

Designed to remove the press fit the solid metalic rear suspension bushings (bushes) / ball joints in the bearing carrier. This tool set allows for on-car installation AND removal of the solid metallic bushing/joint that is located in the bearing carrier/5(37). Oct 10, One of the more confusing project is how to remove bushings on the GM A-Body and G-Body platforms is the rear axle housing bushing.

We use a set of all thread, washers, and nuts to make a DIY bushing removal tool, this also works for replacing bushings as well.

Companies do offer an all-in-one bushing tool if you’re interested in just purchasing check them out below! Comprehensive kit to remove and install balljoints in the rear wheel carrier, balljoints and rubber bearings in the longitudinal arms, rear axle differential bearings on lower axle carrier and rear differential rubber bearings.

The other difference is about the axle removal.

Removal and installation of balljoints on the rear wheel carrier on: 5-Series: E39, E60, E61 and E70 (X5); 6-Series: E63 and E64; 7-Series: E38, E65, E66 and E67; 8-Series: E/5(5). To remove the semi-floating axle, one has to remove a wheel first. And, if such axle breaks, the wheel is most likely to come off the vehicle. The semi-floating design is found under most 1/2-ton and lighter trucks and SUVs and rear-wheel-drive passenger cars, usually being smaller or less expensive models.

rear axle bushing removal