Call us to get tree helping including tree remover, tree trim, bush clearance, shrub drop, stump chopping and a lot of other all over USA:
Call us +1 (855) 280-15-30
This is an essential cookie for the secure checkout and payment.
UPPER CONTROL ARM BUSHING TOOL - UPPER CONTROL ARM BUSHING TOOLIn Stock. Fits: Chevrolet Nova CAM BOLT FOR LOWER CONTROL ARM ECCENTRIC. NovaAdd to Cart.
Ships FREE here for details and exclusions.
UPPER CONTROL ARM SUPPORT TOOL. GM Classics is not associated in any way with General Motors Corporation.
Powerbuilt Kit 25 Upper Control Arm Bushing Service Tool Set for Ford, GM and Chrysler XtremepowerUS Upper Control Arm Bushing Removal Tool Repair for Ford, GM & Chrysler with Carrying Case Dana 30 Axle Side Polyurethane Front Upper Control Arm Bushing Kit fits Cherokee XJ Wrangler TJ Grand Cherokee ZJ WJ/5(45). Aug 16, This is not a control arm, it is a GM bolt rear end.
It uses the same type of rubber bushing. We used the manual method to remove this one. The work-around on this method is to use an air-hammer and chisel the edges of the shell, driving a series of wedges around the shell.
It may feel like a daunting task attempting to determine the best leaf spring for your traditional hot rod straight axle build, but our buyer's guide will surely help.
This will shrink the shell enough to allow you to drive the shell out of the arm without damaging the arm. May 12, - To remove the bushings, I cut the rubber out with a coping saw, and then used a hacksaw to (carefully) cut the outer metal ring.
After that, it just popped out. - I was able to press the bushings in, just using the (new) frame bolt, some pipe (2" on the bushing).