After the face, the cut has been made and the notch is formed, you.

Jan 16, Illustrates how to fell a tree using the Notch and Back-Cut technique. Quick animated sequence to show the expected outcome of implementing the steps describ. Sep 01, how to cut done a tree safely using a notch. how to make a common notch when felling a tree. cutting down a dynamic tree cut r can be made easy and safe when taking proper.

Nov 30, The easiest choice is to fell the tree in the direction it would naturally fall due to slope, overhang and wind direction. Felling in another direction requires a special technique, more effort, and is sometimes just impossible.

In the following video, you can learn proper methods for creating different notches and techniques for maintaining a correct hinge so that you will fell a tree safely and comfortably. Nov 27, 4. Humboldt cut or inverse notch. This is a safe and efficient way to fell a tree that is on a steep slope or prone to splitting. Well suited for thicker trees on steep slopes.

Opening angle of at least 45°. Horizontal cut has the same angle as the felling cut. The felling cut is slightly above level of the directional stumpcutting.barted Reading Time: 6 mins. In order to cut a notch in a tree with a crosscut saw and an axe, the first cut is sawn perpendicular to the grain of the tree with the crosscut saw. Next, an axe chips the wood out using downward angled strikes; it is interesting to observe that an axe chips out wood.

Jan 31, Make a small notch in the tree limb 2–3 feet (– m) from the trunk. You only need to insert your saw about 1/4 of the way through the tree. This cut helps keep the bark from splitting. This is known as your “notch cut.”79%(14). Aug 18, To create the open-face notch, make your top cut first. Cut at a downward angle of 70 degrees until you reach a depth of ¼ to 1/3 of the tree. For the second cut, you will need to saw upward at a degree angle until it meets with the first cut.

These two cuts result in a degree notch, where the other two notches result in a degree notch. For a conventional notch, the back cut should be made about one or two inches above the bottom cut. For a Humbolt notch, the back cut should be made one or two inches above the top cut.

If the tree doesn’t start falling after the back cut has been completed, then you can use a felling wedge as a lever to push the tree in its falling direction.